BRS 150 GPD Water Saver Upgrade Kit

Water Saving Upgrade Kits are probably our most recommended RODI upgrade. If you have proper pressure (65+ PSI) we highly recommend installing the kit, because it will produce water twice as fast as a standard 75 GPD or 100 GPD membrane while cutting the amount of wastewater in half.

The BRS 150 GPD Water Saver Upgrade Kit will increase the production of any 75 GPD reverse osmosis system to 150 GPD without having to use any additional water. With the installation of this kit water production will increase from approximately three gallons per hour to six gallons per hour! It does require 65psi or more into the first membrane in order to function properly and be efficient. If your home's water pressure is less then the recommended PSI do not worry, adding a booster pump is simple and only takes a couple of minutes.

Recommended Conditions:

Minimum Water Pressure - 65 PSI
Max Water Pressure - 90 PSI
Recommended Water Temperature - 77°F
Recommended Max TDS - <300ppm

Water pressure can be increased by adding a booster pump before your RO/DI system if a pressure increase is required. Low pressure will cause slow production of product water, with excess production of wastewater. Pressure over 90 PSI may cause damage to the RO/DI units filters and components.

Recommended Flow Restrictor for 75 GPD RO Systems - 550mL/min

What's Included?

1x Dow RO 75gpd Membrane
2x 2.5" x 2.5" membrane clips
2x 1/8" x ¼" 90-degree elbows
1/8" x ¼" 90° check valve
RO membrane housing*
¼" tube splitter
5 Feet of Red, White, Blue and Black RO Line
*The included 90-degree elbows and check-valve come pre-installed on the RO membrane housing.

DOW Filmtec 75 GPD Membranes have a 96% - 99% typical stabilized salt rejection rate that can be reproduced through the following conditions;